China Factory supplied Boom Cylinder - AC 380V 1.5KW Single Acting Hydraulic Power Packs – Oumai factory and manufacturers

Factory supplied Boom Cylinder - AC 380V 1.5KW Single Acting Hydraulic Power Packs – Oumai

Short Description:

Product Detail

Product Tags

Feedback (2)

We pursue the management tenet of "Quality is superior, Service is supreme, Reputation is first", and will sincerely create and share success with all clients for Diesel Hydraulic Power Pack, Electric Hydraulic Power Pack, Double Acting Hydraulic Hand Pump, Our products are regularly supplied to many Groups and lots of Factories. Meanwhile, our products are sold to the USA, Italy, Singapore, Malaysia, Russia, Poland, and the Middle East.

Factory supplied Boom Cylinder - AC 380V 1.5KW Single Acting Hydraulic Power Packs – Oumai Detail:

Main Specifications

Motor: AC 380V 1.1KW
Solenoid valve: 2/2ways solenoid control valve
Pump displacement: 3.2CC/REV
System flow: 4.5lpm
Tank: 12L steel square tank
Mounting type: Vertical
Hydraulic power unit

Power Voltage	AC110, AC220, AC380, DC12V, DC24V or customized
Moter Power	0.75kw, 1.1kw, 1.5kw, 2.2kw, 3.0kw or customized
Pump Displacement	0.45ml/r, 0.75ml/r, 1.0ml/r, 1.6ml/r, 2.0ml/r, 2.5ml/r, 3.3ml/r, 4.2ml/r,5.8 ml/r or customized
Solenoid Valve Voltage	DC12V, DC24V, AC24V, AC110V, AC220V, manual valve
Mounting Way	Horizontal, Vertical
Mounting position	Valve block, bracket, oil tank, electric motor
System Pressure	10mpa, 16mpa, 20mpa, 25mpa
Capacity of tank	1.7L, 2.8L, 3.6L, 5.0L, 6.0L, 8.0L, 10.0L, 12.0L or customized
Circuit	01-20
Port	3/8″ (BSPP/NPT) or customized
Working	Continute working, short time working
Frequency	50HZ, 60HZ

Precautions for Use

1. Please read the operation manual carefully and check the product model and parameters for correctness.
2. The hydraulic power unit should be installed correctly and connected correctly. Pay attention to whether the voltage of motor and solenoid valve is consistent with the power supply (see electrical schematic diagram), and whether the rotation direction of motor is correct (clockwise from the end of the shaft).
3. Regular
The power unit motor is gap type
4. The work week
The continuous working time of one start is 3 minutes and the rest is 7 minutes. It can not run continuously.
5. The working pressure of the hydraulic power unit has been adjusted when it leaves the factory. In order to maintain a good use state, please do not adjust it casually.
6. The hydraulic power unit should use anti-wear hydraulic oil with a kinematic viscosity of 27 43mm/s(50°C). Ya-n46 is recommended when the oil temperature is lower than 50°C, and YA-N68 is recommended when the oil temperature is higher than 50°C
10~ 25μm filter filter, conventional adding amount is 85~90% of the effective volume of the tank, conventional oil temperature should be within the range of -10~80°C, especially cold areas, low temperature hydraulic oil should be used.

AC-380V-1.5KW-Single-Acting-Hydraulic-Power-Packs07